0000096: adjustments of fuel/ignition

Notes
(0000079) BensDR30 28-06-09 18:28	If you were able to have the system apply tuning parameters to the ECU on power up, then you have effectively made a tunable ECU. This could be a little out of the realm of the display unit to manage, but storage / application of maps via the SD would be a BIG feature.

(0000082) Peter 28-06-09 18:42	the main limitation to this would be the time it takes to 'switch' between different adjustments. so a single adjustment across the board would be fine, but as you increase the frequency of these boundary changes (which may take at least 10ms to maybe 100ms to switch between). but its definitely a possibility, even if its just a small amount of regions. the onboard eeprom could probably store the adjustment points (sdcard wouldnt be fast or reliable enough to), so there would be another limitation against doing too many adjustment points if it cannot all be stored in eeprom.

(0000086) Peter 04-09-09 11:23	this is just for allowing adjustment while on adjustments screen - in future firmware the adjustments may be applied whilst on the main display, once theres a bit more evidence that the adjustments work as intended etc (just to make sure i havent made any mistakes or whatever). theres also a limit of +/-20% fuel (and 10 or 20 ignition timing, forget) in this firmware (this can be increased in future)

Relationships